Filter
Top Products
– 5 –
PL-41426-1
ARM
BOWL COVER
SCRAPER
HANDLE
BOWL
COVER
HANDLE
BOWL HANDLE
BOWL
ALIGNMEMT
PIN
PL-41427-1
ARM
BOWL SCRAPER HANDLE
PL-41425-1
PRESS HANDLE DOWN
THEN TURN
CLOCKWISE
1/8 TURN
TO ENGAGE
PL-41424-1
SHAFT
TAB
BOWL
COVER
TAB
BOWL
COVER
HANDLE
SCRAPER HANDLE
180° CAM
SLOTS
Fit the Bowl Cover over the Bowl Scraper so the
center holes align. Fit the Scraper Handle Shaft
through the center hole in the Bowl Cover into
the Slots of the Bowl Scraper. The Bowl Cover
Tab must fit around the 180° Cam on the Scraper
Handle. The Tabs on the Scraper Handle Shaft
must fit through the Slots in the center hole of the
Bowl Scraper.
Fig. 4
Place the assembled Bowl Cover / Bowl Scraper/
Scraper Handle on a flat surface. Press down on
the Scraper Handle (Fig. 5) and turn it clockwise
1
/8 turn so the Tabs engage with the bottom of the
Slots. The Bowl Cover / Bowl Scraper / Scraper
Handle are now joined as one piece.
Move the Scraper Handle until it is positioned
over the Lid Plug.
Fig. 5
Place the assembled Bowl Cover / Bowl Scraper/
Scraper Handle in the Bowl. The Bowl Scraper
Legs touch the sides of the Bowl. The Bowl
Cover Handles set directly above the Bowl
Handles (Fig. 6). The Alignment Pins under the
Bowl Cover Handles fit the holes in the Bowl
Handles (Fig. 6).
Fig. 6
Swing the Arm forward so the end of the Arm fits
over the center of the Bowl above the Scraper
Handle (Fig. 7). The Arm must be properly
positioned over the center of the Bowl and all
parts must be properly assembled before the
machine will operate.
Fig. 7