Filter
Top Products
– 28 –
Loading Spits Into Oven
1. Place the skewer into the small outside hole on the rotor end plate on your left (as you face the
oven). The back of the V-shape spit should be pointing towards you (Fig.18).
HR7
Fig. 18
2. Fit the other end on the spit into the small corresponding holes on the rotor end plate on your right
(as you face the oven) (Fig.18).
3. Make sure the spit is level. If spit is not level make, sure you are using the correct holes on the
rotor end plates.
Loading Fork Spits Into Oven
1. Place sharp end of spit into holes on the rotor end plate on your left (as you face the oven).
2. Fit the opposite end of spit into corresponding holes in the rotor end plate on your right (Fig. 19).
HR7
Fig. 19
PL-53379
V-SPIT
PL-53378
FORK SPIT