Filter
Top Products
— 5 —
THIS IS AN ADDENDUM TO PAGE 17 OF FORM 34046
Starting a Processing Cycle
1. Press desired Menu Button (its LED will light). Press desired Menu Button once to access
Programs 1-5; twice for Programs 6-10; and three times for Programs 11-15.
2. Press (its LED will light).
• Time display will show total processing time and will count down to the end of the
processing cycle.
• Temperature display will show “pht” (preheat) until oven cavity temperature reaches 125°F
(52°C). Then it will show the actual cavity temperature while maintaining the programmed
temperature.
Displaying Time/Temperature During a Processing Cycle
— If pressed during a processing cycle, probe icon under temperature display will light and
probe temperature will be displayed for 20 seconds. You may press it again if you like.
— Press and hold to display both Cook temperature and time programmed for the Menu Button
you're using.
— Press and hold to display both Grill temperature and time programmed for the Menu Button
you're using.
— Press and hold to display programmed temperature only.
— Press and hold to display programmed time only.
Interrupting a Processing Cycle
1. Press if you want to check the food before the end of the processing cycle.
• This will turn off the heaters, front lamp (customer side), and will flash.
2. Press again to start cycle from where it left off.
3. Press to start all over at the beginning of programmed cycle.
SSERP
UNEM
NOTTUB
1
UNEM
NOTTUB
2
UNEM
NOTTUB
3
UNEM
NOTTUB
4
UNEM
NOTTUB
5
emiT1
margorP
1
margorP
2
margorP
3
margorP
4
margorP
5
semiT2
margorP
6
margorP
7
margorP
8
margorP
9
margorP
01
semiT3
margorP
11
margorP
21
margorP
31
margorP
41
margorP
51