Filter
Top Products
– 22 –
Loading V-Spits or Thermo-Wave Spits on the Rotor (HR5E)
1. Place pointed end of V-spit into outside hole on drive side of rotor (Fig. 19).
2. Fit notched end of V-spit into appropriate holes on non-drive side of rotor (Fig. 18).
3. Make sure the spit is level. If the spit is not level, you might be using the wrong holes.
NON-DRIVE SIDE DRIVE SIDE
Fig. 18 Fig. 19
Loading Fork Spits on the Rotor (HR5E)
1. Place pointed ends of fork spit into appropriate holes on the non-drive side of the rotor (Fig. 20).
2. Fit the notched end of fork spit into appropriate holes on the drive side of the rotor (Fig. 21).
NON-DRIVE SIDE DRIVE SIDE
Fig. 20 Fig. 21
Loading Chicken Racks or Baskets on the Rotor (HR5E)
1. Place non-notched end of Rack or Basket into outside hole on non-drive side of rotor (Fig. 22).
2. Fit notched end of Rack or Basket into appropriate holes on drive side of the rotor (Fig. 23).
Ensure accessory is level.
NON-DRIVE SIDE DRIVE SIDE
Fig. 22 Fig. 23