Filter
Top Products
– 5 –
ELECTRICAL CONNECTION
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH APPLICABLE
PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.
WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.
The mixer grinder is provided with a cord and plug and only requires that it be connected to an
appropriately sized, grounding-type receptacle. Refer to the machine data plate (Fig. 5) and Electrical
Data, below.
ATADLACIRTCELE
ledoMrewopesroHesahP/ztreH/stloV
yticapmAtiucriCmuminiM
eciveDevitcetorPmumixaM
SPMA
elcatpeceRgulP
2351GM
2302GM
dnirGPH5.7
xiMPH1&
3/06/802
0002,rebotcOerofebtliub
03
R03-12L
P03-12L:gulP
3/06/802
0002,rebotcOretfatliub
3/06/042
03
R03-51L
P03-51L:gulP
3/06/08402
R02-61L
P02-61L:gulP
2351GM
dnirGPH5
xiMPH1&
1/06/042-80203
R03-6L
P03-6L:gulP
.noitidetsetal,07-APFN,edoClacirtcelElanoitaNehthtiwecnadroccanidelipmoC
CHECK MOTOR ROTATION (Three-Phase Machines Only)
With the grinder cylinder in place and the hopper lid closed, check the rotation before making a
permanent electrical connection by first pushing the
MIX-GRIND START switch and then pushing the
STOP switch (Fig. 4). The mixing arm and worm should both rotate counterclockwise, when viewed
from the machine's front.
If the mixing arm and worm rotate clockwise, correct the rotation using the following procedure:
DISCONNECT THE ELECTRICAL POWER SUPPLY and interchange any two of the incoming power
supply leads. Reconnect the power supply and push the
MIX-GRIND START switch to verify that both
the worm and the mixer arm rotate counterclockwise as viewed from the front of the machine.
G
Y
Z
X
G
Z
Y
X
G
Y
W
Z
X