Filter
Top Products
– 6 –
CONTROL BOX HEATERS
The Mixer-Grinder has a heater in the control box and another heater in the front control panel to keep
the controls dry. They are automatically ON when the machine is electrically connected. The Mixer-
Grinder should always be connected EXCEPT when performing assembly, disassembly, cleaning, or
maintenance of the machine. After cleaning, reconnect the electrical power supply.
OPERATION
CONTROLS (Fig. 4)
Fig. 4
MIX START Button— Starts rotating the mix arm. Use the Stop Button to stop mixing.
STOP Button — Turns the mixer-grinder off. Turns the Foot Switch off if it was on.
MIX/GRIND START Button — Starts rotating both mix arm and worm. Use the Stop Button to stop
mixing and grinding.
FOOT SWITCH — When On, the Mix Start and Mix/Grind Start Buttons are inoperable and the
accessory Foot Switch can be used to Mix/Grind ONLY. The indicator light shows when the Foot Switch
is On. Push the STOP Button to turn the Foot Switch Off.
HOPPER LID INTERLOCK — An interlock switch requires the hopper lid to be closed before the
machine can operate. Raising the hopper lid opens the electrical circuit and makes the machine
inoperative.
Fig. 5
PL-41181-1
HOPPER LID
LATCH
GRINDER CYLINDER
ADJUSTING RING
MACHINE DATA PLATE
BUSHING RETAINER
FLANGE NUT
FOOT
SWITCH
MIX
START
STOP
FOOT SWITCH OFF
ON
MIX/GRIND
START