Hobart ML-132064 Oven User Manual


 
– 5 –
ELECTRICAL CONNECTION
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
Stacked Ovens
The HRTO can be stacked with model HR7 Rotisserie Oven using the stacking kit (purchased
separately). Refer to the Stacking Kit Installation Instructions included with the stacking kit. Low profile
casters are available as an additional option when stacking ovens under hoods with less than 78"
(198.1 cm) clearance.
ELECTRICAL DATA
Model Volts Hertz Phase Amps
208 60 1 30.1
HRTO
208 60 3 19.9
240 60 1 27.2
240 60 3 19.2
BEFORE FIRST USE
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
The oven must be "burned in" to release any odors that might result from heating new oven surfaces.
1. Clean oven and racks, both inside and outside, with warm soapy water. Refer to "Cleaning" in this
manual for further instructions.
2. Rinse thoroughly and wipe dry with a soft clean cloth. Avoid water contact on the quartz infrared
heat lamp bulbs.
3. Operate oven at maximum temperature setting of 5 for 45 minutes. Smoke with an unpleasant odor
will normally be given off during this burn-in period.