Filter
Top Products
– 4 –
ASSEMBLING BOWL SEAL AND ATTACHMENTS
Refer to the handbook accompanying the cutter mixer for recipe guidelines and advice regarding the
appropriate selection of attachments for the desired application.
WARNING: BEFORE INSTALLING BOWL SEAL AND ATTACHMENTS, BE SURE THE POWER CORD
IS UNPLUGGED.
Bowl Seal: Insert the black seal ring in the groove of the white seal retainer so the thin black edge is down
and the tapered white part on the retainer is up (Fig. 2). Then install the seal onto the motor shaft with
the thin black edge down (Fig. 3). Seat seal securely against the bottom of the bowl with a
1
/4 turn. Store
the extra seal shipped with the machine in a location where you can nd it, if necessary.
Fig. 2 Fig. 3
Strainer Basket: If needed, insert basket in bowl over the
motor shaft.
NOTE: Never use strainer basket and mixing baffl e at
the same time.
Cut Mix Shaft Assembly or Knead Mix Shaft Assembly: Place
on motor shaft, seat square drive at base and tighten hand
knob by turning counterclockwise.
Lid Scraper: Insert on bar opposite mixing baf e. Lid scraper
is used to clean the inside of the bowl cover.
Mixing Baf e: Insert shaft of mixing baf e into hole in the
center of the lid. With baf e paddle down, hold baf e handle
at an angle so lock handle hangs down and insert onto shaft.
Then tighten lock handle (Fig. 4).
Fig. 4