Filter
Top Products
– 7 –
CLEANING
CAUTION: Damage to the lid can result if it is exposed to certain chemicals. Do not use harsh
abrasives, such as powdered or liquid cleansers, steel wool or other abrasive pads; cleaners
containing ammonia, such as window sprays; cleaners containing chlorine, solvents, chemical
adhesives; and highly caustic chemicals, such as drain cleaners or commercial dishwasher
detergents.
Prewash
Before disassembling, put 1gallon of warm water and 1or 2 tablespoons of a mild liquid household
dishwashing detergent, such as Joy, Ivory or Palmolive Green in the bowl. Close and latch the lid. Turn
the timer to JOG and run for three bursts of 3 seconds each so the solution is thoroughly mixed.
Wash Bowl and Components
WARNING: UNPLUG UNIT BEFORE CLEANING.
Remove cut mix shaft assembly or knead mix shaft assembly and, if necessary, the mixing baf e. Do
not leave attachments on motor shaft for storage.
Wash the inside of the bowl and the underneath side of the lid using a soft, clean cloth or sponge. Use
a soft, plastic spatula to scrape the inside of the bowl if food soil adheres to the side of the bowl.
Hand wash the attachments.
Remove the wash water from the bowl.
Rinse
Pour 1 gallon of warm rinse water into the bowl.
Rinse attachments and mixing baf e with water in bowl and remove them to dry. Thoroughly rinse the
inside of the lid and bowl.
Remove the rinse water from the bowl and dry with a clean cloth.
Remove Bowl Seal
Remove the bowl seal by lifting seal up and off of the motor shaft. Separate seal from retainer. Wash,
rinse and dry both parts.
Reassemble seal and retainer (Figs. 2 and 3). Be sure bowl area is properly cleaned before reinstalling
seal. Thin black edge is down; tapered white part is up. Replace seal on shaft, push down rmly and
seal it against the bottom of the bowl with a
1
/4 turn.
NOTE: The bowl seal should be cleaned after every third batch or whenever the product is
changed.
Leave the lid unlatched when machine is not in use.