Hobart ML-134252 Kitchen Utensil User Manual


 
– 7 –
Do not exceed chemical manufacturer’s recommended
concentrations for detergent or sanitizer. Do not exceed
200 parts per million concentration of available chlorine.
For example, mixing 1 tablespoon of 5.25% sodium
hypochlorite bleach with 1 gallon of water yields a solution
containing 200 ppm of available chlorine. Solution with
concentration greater than 200 ppm will accelerate
corrosion of metals. Maximum exposure to sanitation
solution varies with temperature and concentration.
Rinse with clean water.
Reassemble the Sharpener to the mounting bracket by
sliding the left slot on the Sharpener over the left guide
pin on the bracket while tilting slightly (Fig. 6). Then,
press down on the right side of the Sharpener so the
locking hole fits over the right guide pin on the bracket.
Slide the Lock Lever to the right to lock the Sharpener in
position. Make sure the Sharpener is securely engaged
to the pins on the bracket.
Carefully reassemble the Top Knife Cover by putting it
in position (three guide pins). Lock by turning the Latch
Knob counterclockwise while lowering the Top Knife
Cover; then release the Latch Knob and turn it clockwise
until snug.
Replace the Deflector below the slicer knife:
Guide bottom of socket onto mount and rotate inward,
towards the knife.
NOTE: The last three digits of the slicer serial number
are etched on the Key (Fig. 7). Make sure the Carriage
Tray Support Arm stays with its own slicer, otherwise
proper clearances may not be maintained.
To reinstall the Carriage Tray Support Arm: Hold it with
both hands and lower it so the Key at the bottom of the
Support Arm fits into the slot of the Carriage Pivot
(Fig. 7). The Carriage Tray should rest almost horizontal
(Fig. 3). Return the Carriage Tray to the Gauge Plate by
tilting to the left. Turn the Knob on the Carriage Tray
Support Arm clockwise until tight.
To clean underneath the model 2912B slicer, raise the
Lift Lever past center to its stop (Fig. 8). After cleaning,
return the slicer to its normal position by slowly retracting
the Lift Lever.
DO NOT wash any slicer components in a dishwasher. DO NOT immerse slicer base or motor in water.
If using a chlorinated sanitizing solution, dilute per manufacturer’s guidelines. Rinse with fresh water.
NOTE: Failure to follow use, care and maintenance instructions may void your Hobart warranty.
Fig. 6
Fig. 7
Fig. 8