Filter
Top Products
– 20 –
OPERATION
The blower-dryer comes on anytime the pumps are ON. The blower-dryer remains
ON for approximately 15 seconds after the pumps have been turned OFF by
theauto-timerorthetablelimitswitch.If15secondsisinsufcient,timecanbe
increased to a maximum of 10 minutes. Contact Hobart Service for adjustment of
timer setting. The blower-dryer turns OFF immediately when the main machine
power switch is turned OFF.
If the Over Temperature light is ON, there is a failure in the
Blower Dryer. Contact Hobart Service immediately.
CLEANING
The machine must be thoroughly cleaned at the end of each working shift, or at
least twice a day. Use only products formulated to be safe on stainless steel. Use
a damp cloth and mild soapy water.
Never use steel wool to clean warewasher surfaces. Use only products
formulated to be safe on stainless steel.
Removing the Deflector Tray
Thedeectortraycanberemovedforcleaningandmaintenance.
DOs and DON'Ts for your New Hobart Blower-Dryer
DO pre-scrap dishes thoroughly.
DO, at the end of the day, thoroughly clean the machine, rinse and dry.
DO use only products formulated to be safe on stainless steel.
DO NOT allow food soil to accumulate on the tank bottom.
DO NOT use steel wool to clean ware or warewasher surfaces.
DO NOT allow foreign objects to enter the unit, especially metallic contaminants.
NOTE: Failure to follow use, care and maintenance instructions may void your
Hobart warewasher warranty.
F44181 Rev. E (June 2013)
PRINTED IN U.S.A.