Filter
Top Products
– 8 –
Fig. 5
ASSEMBLE ELASTIC STOP NUTS AT
END OF R
ODS FOR CORRECT ADJUSTMENT.
DO NOT OVERTIGHTEN NUTS.
THIS MAY CAUSE CONVEYOR TO BIND
0.15 - 0.020" GAP IS PREFERRED.
(4 PLACES)
TRACK ROD
APPROX.
1.00"
TANK END
Fig. 6
TRACK ADJUSTMENT
Place a rack on the track in the center of the Blower-Dryer unit. Verify that there is
less than 0.25" total gap between the rack and the track. Adjust track rod as needed.
DISH TABLE ASSEMBLY
Dishtablesshouldbettedintotheblower-dryer(Figs.6,7&8).Usesiliconesealant
between table and lip of tank to prevent leakage. Rack track height should be from
1
/4 to
5
/16" (Fig. 7) above the tank lip. Dish tables should be sloped so that any water
carried from the dishwasher will drain back into the machine.
NOTE: Theblower-dryermustbeinitsnalposition,adjustedforproperheight
and properly leveled before table assembly and plumbing connections are made.