Filter
Top Products
– 12 –
PL-40172-1
Bowl Lift Slideways
FORM 18815 Rev. A (12-99) PRINTED IN U.S.A.
SERVICE
If service is needed on this equipment, contact your local Hobart Service Office.
Bowl Lift
The bowl lift mechanism should be lubricated twice a year. Remove the screw and access cover from the
rear of the pedestal. Lightly coat moving parts with Lubriplate 630AA (supplied). Replace access cover
and tighten screw.
Bowl Lift Slideways
The slideways (Fig. 6) should be lubricated once each month. Remove the apron (secured by four thumb
screws) from the front of the pedestal. Lightly coat both slideways with Lubriplate 630AA (supplied).
Replace the apron and thumbscrews.
Fig. 6
TROUBLESHOOTING
SYMPTOMS POSSIBLE CAUSES
Mixer will not start. 1. Gear shift lever between gears (not fully engaged).
2. Circuit protector in open position — check fuse or
disconnect switch.
3. Mixer or attachment overloaded.
4. Bowl not all the way up.
5. Wire Cage Assembly is not in the front-center position.