Filter
Top Products
– 3 –
OPERATION
WARNING: MOVING BEATER IN BOWL. KEEP HANDS, CLOTHING, AND UTENSILS OUT WHILE
IN OPERATION.
CONTROLS
The ON-OFF SWITCH is used to start and stop the mixer.
The GEAR SHIFT LEVER (Fig. 1) is used to change speeds. Always stop the mixer before changing
speeds. To change speeds, turn the switch Off, move the gear shift lever to the desired speed, and
turn the switch back On. NOTE: There is a mechanism which prevents the gear shift lever from
being moved with the switch in the ON position, and also prevents the switch from being turned ON if
the gear shift lever is between gears.
Speed 1 (Low) — This speed is for
heavy mixtures such as bread dough,
heavy batters, and potatoes.
Speed 2 (Medium) —This speed is
for light dough which must rise
quickly, cake batters, and some
whipping operations.
Speed 3 (High) — This is a fast
speed for light work such as whipping
cream, beating eggs, and mixing thin
batters.
The BOWL LIFT HANDLE is used to
raise and lower the bowl. To raise
the bowl, rotate the handle upward;
rotating the handle downward lowers
the bowl.
MIXING
This section explains operation of the mixer and how to install bowls, agitators, and attachments. A
separate
Use and Applications Handbook
is provided with the mixer which contains information on
mixing procedures and outlines specific uses for agitators, attachments, and accessories.
Bowl
New mixer bowls and agitators (beaters, whips, and dough arms) should be thoroughly washed with
hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly
rinsed with clear water BEFORE being put into service. This cleaning procedure should also be
followed for bowls and agitators before whipping egg whites or whole eggs.
The bowl must be installed before the agitator. To install the bowl, fully lower the bowl support (Fig. 1).
Position the bowl so the alignment bracket on the back of the bowl is in the bowl retainer and the
alignment pins (Fig. 1) on the front of the bowl support fit in the holes on the sides of the bowl. Lock
the bowl in place by rotating the bowl clamps (Fig. 1) over the ears of the bowl.
Agitator
To install an agitator, the bowl must be installed and fully lowered. Place the agitator in the bowl, push
it up on the agitator shaft (Fig. 1), and turn it clockwise to seat the shaft pin in the slot of the agitator
shank.
Fig. 1
Bowl Clamp
PL-53472