Filter
Top Products
– 4 –
FORM 15340 Rev. B (Feb. 2000) PRINTED IN U.S.A.
Attachments
To install an attachment, loosen the thumb screw on the attachment hub (Fig. 1) and remove the plug.
Insert the attachment into the attachment hub making certain that the square shank of the attachment
is in the square driver of the mixer. Secure the attachment by tightening the thumb screw.
Move the gear shift lever to the desired speed and start the mixer to operate the attachment.
The meat and food chopper attachment should be operated in second or third speed. If material in the
cylinder stalls the mixer, stop the mixer at once. DO NOT attempt to restart the mixer in a lower speed
— remove the adjusting ring, knife, plate, and worm and clear the obstruction. THIS ATTACHMENT
MUST NOT BE USED TO CHOP BREAD CRUMBS.
NOTE: Attachment hub should not be used while mixing.
CLEANING
WARNING: UNPLUG MACHINE POWER CORD BEFORE BEGINNING ANY CLEANING PROCEDURE.
The mixer should be thoroughly cleaned daily.
Bowls and agitators should be removed from the mixer and cleaned in
a sink.
DO NOT use a hose to clean the mixer — it should be washed with a
clean damp cloth.
Remove the agitator spring for cleaning. Slip the lower end of the spring
underneath the agitator pin and screw in a counterclockwise motion until
the spring comes off (Fig. 2). After cleaning, reinstall the agitator spring
by reversing this procedure. All coils of the spring should be above the
agitator pin. DO NOT OPERATE AGITATORS WITHOUT THE
AGITATOR SPRING IN PLACE.
The drip cup (Fig. 1) should be removed periodically and wiped clean.
MAINTENANCE
WARNING: UNPLUG MACHINE POWER CORD BEFORE BEGINNING ANY MAINTENANCE PROCEDURE.
Bowl Lift Slideways
The slideways (Fig. 1) should be lubricated twice a year. Apply a light coat of Lubriplate 630AA to all
three surfaces of both slideways.
SERVICE
If service is needed on this equipment, contact your local Hobart Service Office.
Fig. 2
PL-53473