Filter
Top Products
11
If the sink is 34 or higher from the floor, the excesswater in Unicouple hoses
cannot be drained directly into the sink. It will be necessary to drain excess
water from hoses into a bowl or suitable container that is heldoutside and lower
than the sink.
Connect the coldwater supplyhose to athreaded3/4(inch) connectorandmakesure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, letthe water
runtomakesurethatthewaterisclearandfreeofimpurities.Ifthisprecaution is not taken,
thereis a risk that thewater inlet can get blockedand damage the appliance.
The watersupply to the appliance can also be connectedtothe house hot waterline
(centralized system, heatingsystem),as longas it does not exceed a temperature of 60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and thewash
efficiencyslightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.
DIMENSIONS(mm)
Insert the drain hoseinto a drain pipe with aminimum diameter of4 cm, or let itrunintothesink,makingsuretoavoidbending
or crimping it. Use the special plastic support that comes with the appliance.The free endof the hose must beata height
between 40 and 100cm and must not be immersed in water.
Once the appliance is positioned,adjust the feet (screwing them in or out) to adjust the
height of the dishwasher, making it level. In any case ,the applianceshould notbeinclined
more than 2 .
Position the appliance inthe desired location. The back should rest against the wallbehind it, andthe sides, along the adjacent
cabinets orwall. The dishwasher isequippedwithwater supplyanddrain hoses that canbepositionedto the right orthe left to
facilitate properinstallation.
φ 40mm