Hoshizaki AM-50BAE Ice Maker User Manual


 
- 9 -
AM-50BAE: The control switch is marked
“ICE- OFF-WASH” and is located on the
lower right front of the unit.
AM-100 & AM-150: The control switch is
located on the control box which is located
behind the front panel on the left hand side
of the unit.
If it is necessary to gain access to the control
box,
the louvered panel must be removed.
AM-50BAE: This can be done by removing
the two screws from the lower portion of the
front panel and pulling the panel down
slightly to dis-engage the mounting tabs.
AM-100 & AM-150: Remove the middle
screw at the bottom of the front panel and lift
off.
The control box is held in place with 2 hex
head bolts. Once the bolts are removed,
AM-50BAE: The control box can be rotated
approximately 45° CCW allowing easier
access to the control box cover and control
board.
AM-100 & AM-150: The control box can be
pulled out to the front of the unit after the
two bolts have been removed.
(AM-100 & AM-150)
(AM-50BAE)
(AM-100 & AM-150)
(AM-50BAE)