Hoshizaki AM-50BAE-AD Ice Maker User Manual


  Open as PDF
of 34
 
32
B. Maintenance
IMPORTANT
This icemaker must be maintained individually, referring to the instruction
manual and labels provided with the icemaker.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
2. Storage Bin and Scoop
•Washyourhandsbeforeremovingice.Usetheplasticscoopprovided.
•Thestoragebinisforiceuseonly.Donotstoreanythingelseinthestoragebin.
•Cleanthescoopandthestoragebinlinerusinganeutralcleaner.Rinsethoroughly
after cleaning.
3. Condenser
Check the condenser once a year, and clean if required by following the steps below.
More frequent cleaning may be required depending on location.
WARNING
1.Movethecontrolswitchtothe"OFF"positionandunplugtheunitfromthe
electrical outlet before cleaning the condenser.
2. Condenser ns are sharp. Use care when cleaning.
1)Movethecontrolswitchtothe"OFF"positionandunplugtheunitfromtheelectrical
outlet.
2) Remove the 2 screws securing the front panel, then
remove the panel. See Fig. 47.
3) Remove the 2 screws securing the louver, then
remove the louver.
4) Use a brush attachment on a vacuum cleaner to
gently clean the condenser ns. Do not use too
much force, otherwise the ns could be damaged.
5) Replace the louver and front panel in their correct
positions. Ensure that the screws are securely in
place.
6)Plugtheunitbackin.Movethecontrolswitchtothe"ICE"positiontostarttheautomatic
icemaking process.
Front Panel
Louver
Fig. 47
Screws
Screws
Condenser
 previous next