Filter
Top Products
14
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with all applicable national,
state, and local regulations.
. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the dispenser unit/storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic lm from the panels. If the icemaker is exposed to the
sun or to heat, remove the lm after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specied on the nameplate.
• Flaker models can be installed on a storage bin " wide or wider. Cubelet models can
be installed on either a dispenser unit or a storage bin " wide or wider.
• If using a storage bin, Hoshizaki Ice Storage Bin, Model B-300 series is recommended.
For further options, contact your local Hoshizaki distributor.
• On remote air-cooled model, a remote condenser unit is needed. Hoshizaki Remote
Condenser Unit, Model URC-5F is recommended.
• On low-side models, an R-404A parallel rack system is needed. See "II.G. Connection
to an R-404A Parallel Rack System" for refrigeration circuit details.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and towards
you.
• Top Panel: Lift up at the front slightly, push rearward,
and lift off.
• Side Panels: Remove the screw. Slide forward
slightly and lift off.
Fig. 1
Top Panel
Front Panel
Side Panel
Side Panel