Filter
Top Products
4
7) Connect the refrigerant lines to the appropriate ttings on the rack system rst (if not
already brazed on), then at the icemaker.
If the couplings to the rack system are not Parker quick connect couplings, follow the
coupling manufacturer's instructions. Make a proper Parker quick connect coupling
connection as follows:
a. Remove the protective covers from the male tting and female coupling.
b. Apply Polyol Ester (POE) refrigerant oil to the entire male tting, including threads,
o-ring, and diaphragm, before making the connection. See Fig. 1.
CAUTION
Do not use thread sealant on the ttings. Use POE refrigerant oil only.
c. Make sure the male tting and female coupling are properly aligned, then start the
connection by hand to ensure that it is not cross threaded.
d. Place a backup wrench on the back of the female coupling, then tighten the
connection with a wrench until it is tight. At this point, the nut has covered most of
the threads on the male tting. CAUTION! Failure to use a backup wrench may
result in damage to the line set and possible refrigerant leaks.
e. Mark a reference line on the female coupling and the unit panel. Using a backup
wrench on the back of the female coupling, tighten the six-sided nut of the female
coupling an additional 1/6 turn. See Fig. 13.
8) Open the rack system service valves.
Female Coupling
(Charging Ports)
3/8" OD Suction Line
(Insulated)
Rack System-Threaded Connection
1/4" OD Liquid Line
(Insulated)
Icemaker
Male Fitting
Service Loop
Fig. 11
Female Threaded Coupling
Rack System-Braze Connection
Male Threaded Fitting
3/8" OD Suction Line
(Insulated)
1/4" OD Liquid Line
(Insulated)
3/8" OD Suction Line
(Insulated)
1/4" OD Liquid Line
(Insulated)
Braze Conneciton