Filter
Top Products
6
I. Installation Instructions
WARNING
• This unit must be installed in accordance with applicable national, state, and local
codes and regulations.
• This unit is heavy. Use care when lifting or positioning. Work in pairs when needed
to prevent injury or damage.
• Do not tilt the unit more than 45°.
A. Checks Before Installation
• Visually inspect the exterior of the shipping package and immediately report any damage
to the carrier. Upon opening the package, any concealed damage should also be
immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. Also remove the protective
plastic lm from both the exterior panels and the interior door panel. If the unit is exposed
to the sun or to heat, remove the lm after the unit cools.
• Remove all accessory containers before discarding the packing materials.
B. Location
1. General
This unit is approved for indoor or outdoor use.
NOTICE
Normal operating ambient temperature must be within 61°F to 95°F (16°C to 35°C).
Operation of the unit, for extended periods, outside of this normal temperature
range may affect unit performance.
For best operating results:
• The unit should not be located next to ovens, grills, or other high heat producing
equipment.
• The location should provide a rm and level foundation for the unit.
• The unit should not be located in a corrosive environment.
• The unit must have a minimum of 1" (3 cm) clearance at bottom and top. Air must be able
to circulate freely under, behind, and above the unit.