Filter
Top Products
8
C. Door Reversal
If you would like to reverse the door swing, follow the steps below. Otherwise, skip to
section "II.D. Setup."
1) Make sure the unit is off and unplugged.
2) Remove the fasteners securing the top panel. See Fig. 1. Being careful not to pull on the
wires to the control panel and door switch, lift off the top panel. Secure the top panel so
that it does not interfere with the upper hinge or top panel bracket and will not fall.
3) While maintaining a hold on the door, remove the fasteners securing the upper hinge to
the right side of the unit. Lift off the door and upper hinge.
4) Remove the top panel bracket from the left side of the unit, then secure it to the right
side of the unit.
5) Remove the 2 outside plastic plugs from the lower left side of the unit.
6) Remove the lower hinge from the right side of the unit, then secure it to the left side of
the unit.
7) Place the 2 plastic plugs in the holes on the lower-right side of the unit.
8) Remove the plastic plugs and the handle from the door.
9) Secure the handle to the right side of the door. Place the plugs in the open handle holes
on the left side of the door and in the hinge hole on the right side of the door.
10) Place the door onto the lower hinge, then place the upper hinge in the door and secure
to the left side of the unit.
11) Make sure the door is level. If not, adjust the door using the slots in the hinges.
12) Check that the wiring is connected and routed properly, then replace the top panel in its
correct position. Secure the top panel.
Plastic Plugs
Top Panel Bracket
Handle
Upper Hinge
Lower Hinge
Plastic Plugs
Fig. 1
Control Panel
Door Switch
Top Panel