Filter
Top Products
2
4) Remove the protective plastic film from the panels. If
the icemaker is exposed to the sun or to heat, remove
the film after the icemaker cools.
5) Check that the refrigerant lines do not rub or touch
lines or other surfaces, and that the fan blade turns
freely.
6) Check that the Compressor is snug on all mounting
pads.
7)
See the Nameplate on the Rear Panel, and check that
your voltage supplied corresponds with the voltage
specified on the Nameplate.
8)
Remove the shipping tapes securing the Cube
Guide.
2. HOW TO REMOVE PANELS - See Fig. 12. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 12. HOW TO REMOVE PANELS - See Fig. 1
2. HOW TO REMOVE PANELS - See Fig. 1
Fig. 1Fig. 1
Fig. 1Fig. 1
Fig. 1
a) Front Panel . . . . . Remove the two screws.
Lift up and pull toward you.
b) Top Panel . . . . . .
Remove the two screws,
and then lift off.
c) Side Panel (R) . .
.
Remove the screw.
Pull slightly toward you, and
take off.
d) Insulation Panel . .
Remove the Thumbscrew.
Lift up slightly, and pull
toward you.
IMPORTANTIMPORTANT
IMPORTANTIMPORTANT
IMPORTANT
1.
In order to carry out safe and proper installa-
tion of the product, please read this booklet
carefully beforehand and follow the instruc-
tions contained within.
2. On completion of the installation, start the
icemaker to check for any abnormalities, and
instruct the user on how to use and maintain
the icemaker in accordance with the Instruc-
tion Manual.
3. This booklet should be handed over to the
user after the installation and be preserved
by the user together with the Instruction
Manual for any further consultation that may
be necessary.
WARNINGWARNING
WARNINGWARNING
WARNING
The installation must be carried out by qualifiedThe installation must be carried out by qualified
The installation must be carried out by qualifiedThe installation must be carried out by qualified
The installation must be carried out by qualified
personnel,personnel,
personnel,personnel,
personnel, in accordance with current regulations,
according to the manufacturer’s instructions.
1. UNPACKING1. UNPACKING
1. UNPACKING1. UNPACKING
1. UNPACKING
WARNINGWARNING
WARNINGWARNING
WARNING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Remove shipping carton, tape(s) and packing. If
packing material is left in the icemaker, it will not
work properly.
Note: 1. This icemaker needs a storage bin. The
recommended storage bin is HOSHIZAKI
ICE STORAGE BIN, Model B-800 series.
2. The remote air-cooled model requires
HOSHIZAKI REMOTE CONDENSER UNIT,
Model URC-12F-E.
1) After removing the packaging, make sure that the
icemaker is in good condition. If in doubt, please do
not use the equipment but apply to professionally
qualified personnel. See the instruction sheet at-
tached to the Storage Bin for its unpacking and
installation guidelines.
2) Remove the panels to prevent damage when
installing the icemaker. (See “2. HOW TO REMOVE
PANELS.”)
3) Remove the package containing the accessories
from the compressor compartment.
ENGLISH