Filter
Top Products
15
GB
Care and Cleaning
Grill
Remove the grill pan and the wire grid food support,
it is best to wash these items immediately after use
to prevent stains from being burnt on when used
again. Wipe out the Grill compartment, use a fine
steel wool soap pad to remove stubborn stains from
the grill runners and the floor of the compartment.
Wipe over the control panel with a damp cloth and
polish with a dry cloth.
Control Panel
Do not use Do not use
Do not use Do not use
Do not use cream cleaners, oven cleaners or
aerosols, scouring pads or abrasive powder for
cleaning the plastic knobs as damage will occur.
Decorative Trims
It is advisable to clean the decorative trims regularly
to prevent any build up of soiling. The
recommended method of cleaning is to wipe over
the trims with a soft cloth wrung out in warm water or
mild non-abrasive cleaner. (If in doubt try the cleaner
on a small area of trim which is not noticeable in
normal use). Then, after wiping with a cloth wrung
out in clear water, dry with a soft clean cloth.
Doors
Wipe over the outer door glass panels with a cloth
wrung out in warm soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft
clean cloth.
Ensure that glass doors are notEnsure that glass doors are not
Ensure that glass doors are notEnsure that glass doors are not
Ensure that glass doors are not
subjected to any sharp mechanical blows.subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
Glass Inner Door Panel (where fitted) *
Open the door fully
and unscrew the two screws
securing the glass panel,
taking care not to allow the
glass to fall. The glass panel may now be washed at
the sink. Stubborn stains can be removed by using
a fine steel wool soap pad.
Ensure the glassEnsure the glass
Ensure the glassEnsure the glass
Ensure the glass
panel is not subjected to any sharppanel is not subjected to any sharp
panel is not subjected to any sharppanel is not subjected to any sharp
panel is not subjected to any sharp
mechanical blows. mechanical blows.
mechanical blows. mechanical blows.
mechanical blows. Take particular care not to
damage the inner surface which is coated with a
heat reflective layer. After cleaning, rinse and dry
with a soft cloth. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
Take care Take care
Take care Take care
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care Take care
Take care Take care
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.
Top Cavity
Remove the rod shelves and grill pan. Use a fine
steel wool soap pad to remove stubborn stains from
the rod shelves, grill pan and the floor of the oven.
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
Main Oven Cleaning
Main oven is fitted with “Stay Clean” panel.
'Stay Clean' panels are covered with a special enamel
which absorbs cooking soils. At higher temperatures
the soiling is slowly destroyed. In most cases normal
cooking at higher temperatures will permit this cleaning
to take place automatically. However, if higher cooking
temperatures are not used regularly then it may be
necessary, in order to prevent heavy soiling, to run the
oven at maximum temperature for at least two hours,
from time to time. The 'Stay Clean' panel can be
washed in warm soapy water followed by rinsing in
clear water. Dry well with a soft cloth.
NOTE: Do not use enzyme washing powder, harsh
abrasives or chemical oven cleaners of any kind.
Oven Shelf Supports
The shelf supports are removable and dishwasher
safe.
To remove To remove
To remove To remove
To remove hold the support at the front and pull
away from the oven side, this can then be cleaned in
a sink or a dishwasher. When removed it allows
access to the oven side, which can be cleaned with
warm soapy water.
To refit To refit
To refit To refit
To refit the support, insert the longer leg into the
rear fixing hole and push in the front leg.
Replacing the Battery
The battery is not covered bye the guarantee. Use
an alkaline AA battery. The battery holder is located
in the plinth panel below the oven door. Open the
oven door fully. Press the tag on the left hand side
of the battery holder/cover and withdraw it just
enough to get access to the battery. Fit the new
battery with the end marked “+” on the same side of
the battery holder as the red lead. Replace the
battery holder by pushing it firmly into the hole in the
plinth.
* (only available on certain models)