Filter
Top Products
7
GB
Installation
c)c)
c)c)
c)Minimum regulation of the hob burners:
• turn the tap to minimum;
• remove the knob and adjust the regulation screw,
which is positioned in or next to the tap pin, until
the flame is small but steady.
! !
! !
! In the case of liquid gas, the regulation screw
must be screwed in to
the bottom.
• check that the flame
does not turn off when
you turn the tap quickly
from high to low.
d)d)
d)d)
d)Regulating the primary
air of the burners:
The primary air of the
burners requires no regulation.
Adapting to different types of gas
In order to adapt the oven to a different type of gas
with respect to the gas for which it was
manufactured (indicated on the label), follow these
simple steps:
a)a)
a)a)
a) Replacing the oven burner nozzle
• open the oven door fully
• pull out the sliding oven bottom
V
V
Z
• Pry the fixing tab “V” and remove the oven burner
• Unscrew the oven burner nozzle using the socket
spanner for the nozzles
“Z”“Z”
“Z”“Z”
“Z”, or a 7 mm socket
spanner, and replace it with a nozzle suited to the
new type of gas (see Table 1).
Take particular care handling the sparkTake particular care handling the spark
Take particular care handling the sparkTake particular care handling the spark
Take particular care handling the spark
plug wires and the thermocouple pipes.plug wires and the thermocouple pipes.
plug wires and the thermocouple pipes.plug wires and the thermocouple pipes.
plug wires and the thermocouple pipes.
• Replace all the parts, following the steps
described above in the reverse order.
b)b)
b)b)
b)Minimum regulation of the gas oven burner with
thermostat:
• light the burner as described in the paragraph
“the oven knob” of the instruction booklet.
• turn the knob to
MaxMax
MaxMax
Max for about 10 minutes and
then turn the knob to the
MinMin
MinMin
Min setting;
• remove the knob;
• regulate the screw positioned outside the
thermostat pin until the flame is small but steady.
!!
!!
! In the case of liquid gas, the regulation screw must
be screwed in to the bottom.
• check that the burner does not turn off
when youwhen you
when youwhen you
when you
turn the knob from Maxturn the knob from Max
turn the knob from Maxturn the knob from Max
turn the knob from Max
to Minto Min
to Minto Min
to Min and and when
you open and close the oven door quickly.
Adapting the gas grill to different types of gas
Replacing the nozzle of the grill burner:
• remove the screw and then slide out the grill
burner “
VV
VV
V” (see Fig. E);
• unscrew the grill burner nozzle using the special
socket spanner for the nozzles (see Fig. F) or
better still a 7 mm socket spanner; replace the
nozzle with a nozzle for the new type of gas (see
table 1).