Filter
Top Products
33
Important
It is essential that the lower cupboard is constructed in the manner illustrated
i.e. having side, back, and roof panels so joined as to provide no apertures which
could permit access to the oven unit when installed.
1. General
The appliance is designed for mounting at a safe level into an oven housing which
must be secured to the backing wall.
2. Ventilation
a. The oven housing unit cabinet dimensions must comply with fig. 4.
b. An air gap of 50mm minimum must be provided at the rear of any top or
bottom cupboards or shelves (see fig. 1).
c. It is necessary that the cabinets are provided with unobstructed ventilation,
i.e. from adjacent cabinetry. This can be done by either raising the base of
the cabinets using the adjusting feet (or spacers) or alternatively by
providing a slot in the cabinet plinth to the dimensions in fig. 1.
d. The air gap at rear allows the warmed air to pass out of the inner cabinet
space. Where it is intended to fit cupboards above the oven unit to ceiling
height, it is essential that the warmed air is exhausted through the front of
the cabinet (see fig. 1).
e. If an oven unit is installed adjacent to a tall cabinet, steam escaping from
the oven when the door is opened could condense on and maybe stain the
adjacent surface. To prevent permanent staining, the adjacent surface
should be made of a material that is heat resisting and easy to clean.
Adjacent tall cabinets should not be deeper than the oven housing cabinet.
3. Final Installation
a. Using a spirit level, check that the housing cabinet is level from side to side
and from front to back in its installed position.
b. Correct any unevenness by placing spacers under the bottom of the cabinet.
Make sure that the cabinet rests firmly on the floor without rocking.
c. Before the oven is fitted, the cabinet must be firmly secured to the backing
wall for stability.
d. The oven unit should now be lifted (this is a two person lift) into the cabinet
and pushed fully home.
e. Finally, the oven is secured to the cabinet by means of the four Phillips C/SK
Head screws - two through each side trim.
f. Remove all packaging material from the grill and oven interior.
List of loose items:
4 x Phillips C/SK Head No. 6 x 25mm screws.
Installation