Filter
Top Products
If something goes wrong ...
32
To minimise the risk of injury to children please dispose of your product carefully and
safely. Remove all doors and lids. Remove the mains cable (where fitted) by cutting off
flush with the appliance and always ensure that no plug is left in a condition where it
could be connected to the electricity supply.
To help the environment, Local Authority instructions should be followed for the disposal
of your product.
Disposal of your product
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of in the
normal unsorted municipal waste stream. Old appliances must be collected separately in
order to optimise the recovery and recycling of the materials they contain and reduce
the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your
obligation, that when you dispose of the appliance it must be separately collected.
Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance.
continued...
Timer is flashing
‘00.00 ’
The power supply to your oven has possibly been
interrupted, but has now come back on again. Reset the
timer to the correct time of day using the instructions
given in the timer section of the book.
Oven temperatures too
high or low
Check temperature and shelf positions are as
recommended in the Oven Temperature Charts.
It may be necessary to increase or decrease the
recommended temperature slightly to suit your taste.
Oven does not cook
evenly
Check:
(a) Temperature and shelf positions are as recommended
in the Oven Temperature Charts.
(b) Oven utensils being used allow sufficient air flow
around them.
Oven light does not
work
The oven light is not covered by the guarantee. The part is
easily changed (see section 'Replacement of Oven Light').
A new light bulb may be obtained from our Parts
department see Key Contacts, back page.
Draught from beneath
control panel
A gentle flow of air will be blown from beneath the control
panel when the appliance is used. If the appliance is still
warm, this cooling fan may run on, or restart itself when all
controls have been turned off.
The fan will stop once the appliance has been cooled. This is
normal and not
a fault.
Steam is a by - product of cooking any food with a high
water contact. To help minimise always:
(a) Try to avoid leaving food in the oven to cool after
being cooked.
(b) Use a covered container, wherever possible.
Steam / Condensation in
the oven after use.
PROBLEM CHECK