Filter
Top Products
Care and Cleaning
35
Warning: Before cleaning, please ensure that the electricity supply to the appliance is switched off
and the appliance is fully cold.
Before switching on again, ensure that all controls are in the OFF position.
DO NOT use biological washing powder, harsh abrasives, scouring pads, aerosol cleaners or
chemical oven cleaners of any kind (unless specified below), as this could damage the
“Stayclean” oven liners.
1. Plastic or nylon pads / scourers, these may scratch the surface.
2. Household abrasive powders.
3. Oven chemical cleaners, aerosols and oven pads.
Caustic cleaners such as these will etch the surface and attack the
metal frame.
4. Bath and sink cleaners may mark the surface.
The cleaning of sealed hotplates should be done when they are cold,
using a soap filled Brillo pad, following the
grain of the hotplate. This will
ensure that any stubborn,
burnt on spillages are removed. Wipe over with
a damp clean cloth, making sure that all the cleaner has been removed.
Finally, turn on hotplate to warm for a few minutes, then smear with a
little cooking oil to provide a protective coating, or the restorative agent
Homecare Four Hob, available from Genuine Parts & Accessories (see Key
Contacts, back page) or leading supermarkets. The bezels will mellow with
use to a burnished gold colour, a soap filled Brillo pad will help to keep
them bright, care should be taken not to damage the vitreous enamel hob
surface.
Note: We do not recommend the use of decorative covers over the hot
hotplates as these can hold condensation and cause corrosion. Accidental
operation with a cover in place can cause intense heat. Never place
saucepan lids on the hotplates, as this may cause corrosion.
To reduce the amount of cleaning always ensure that the hob and
cooking utensils are clean and dry before use. Regular use of cleaner
conditioner is recommended for proper care and protection of the hob
surface. Apply conditioner before using the hob for the first time. It
contains a mild cleaning agent, so that subsequent applications may
clean off soil and apply a protective film at the same time. For stubborn
stains or heavy soiling use any of the following materials, and finish off
with conditioner.
1. Cif, non-scratch scouring cream.
2. Liquid Gumption Kitchen Cleanser.
3. Special Powder Cleanser.
Powder Cleanser – Mineral deposits that are present in hard water, and
some foods, may cause ‘discolourations’ that appear in the form of grey
or brown stains. The stains sometimes appear to be in or under the glass
surface. If there are some persistent stains after using any of the other
recommended cleaning materials, powder cleanser may be applied,
following the manufacturers instructions. Do not use abrasive cleaners
or the powder cleanser on the painted metal framework.
Cleaner Conditioner – Regular use of the conditioner will make the
surface easier to clean thus ensuring that years of heavy abrasive
cleaning do not progressively dull the surface.
Cleaning materials
to avoid
Electric sealed
hotplates
(EW32 & EW34)
Ceramic hob
(EW42, EW45 &
EW52)