Filter
Top Products
The SYSTEMS
MONI~R
(continued)
DISPLAY
#-#-/
::-/
WHAT IT
MENS
The water temperature in the
dishwasher did not reach the
proper wash temperature. This
is usually caused by lack of hot
water coming from the household
water heater.
The temperature sensor in the
dishwasher is not functioning
properly. Dishwasher may continue
to be used, but it will not heat
water automatically.
The detergent cup did not open.
This is usually caused by a utensil
or dish.
Before you call for service
●
Try the cycle again to see if the
Code reappears. The dishwasher
may correct itself.
● Electronic controls can be
affected by outside interference.
. Sometimes shutting off the power
to the dishwasher (at the fuse or
circuit breaker) will correct the
problem.
●
Restore power after about five
seconds and try the cycle again.
●
Check the guide on pages 8-10
for things you can do to correct the
problem.
WHAT TO DO
Avoid showers or laundry just prior to running the dishwasher.
(Use the “DELAY START” feature to start dishwasher
when the water heater is up to normal temperature. ) Adjust
household water heater thermostat to
120°F.
minimum.
If C6 appears nearly every cycle and you know the water
from the household water heater is hot
(120°F.
or more), call
for service.
The temperature sensor needs to be
replacd.
Call for service.
N~E:
You may continue to use your dishwasher. For best results,
adjust your household water heater thermostat to
140°F.
1. Unlatch and open the dishwasher door.
2. Check for utensils and dishes that could have blocked the
detergent cup from opening. Rearrange if necessary.
3. Close and
relatch the door. Wait for 30 seconds. This will
allow time for the cup to open by itself.
4. If the detergent cup is still closed, open it by hand and
remove the old detergent. See page 13.
10