Hotpoint RC32P Freezer User Manual


 
4
Installation
Choosing a Location
The freezer should be placed in a dry, ventilated room and never close to a radiator or other
sources of heat, as this will increase the power consumption unnecessarily.
Please make sure that the freezer is installed on a level surface and in a position providing
adequate air circulation to the sides and rear of the freezer, also make sure the lid can be
opened fully.
If the freezer is installed on a thick pile carpet it should be elevated to ensure free air circulation
underneath.
The freezer should not be positioned where it will be affected by draughts or dampness.
The siting of freezers in unheated outhouses or garages may, in cold weather, give rise to
condensation forming on the outer surface of the freezer. This is no way due to faulty operation
of the freezer and will disappear with warmer weather.
Remove condensation with a clean, dry cloth.
If placed in a garage or outside location it is recommended that a coating of wax polish be
applied to the outside of the freezer.
Before Using your Freezer
It is recommended that you clean both the inside and the outside of the freezer before using it
for the first time. Use lukewarm water and a little bicarbonate of soda; 1 teaspoon to 1.2 litres of
water.
NOTE: The freezer should be allowed to stand for 2-3 hours, to allow the system to settle,
before it is turned on for the first time.