Filter
Top Products
,.. . ,.,~
E?emovableOvenBO~~Om
YOU
can removetheovenbottom
to clean anyexcessivespillovers
beforestartingthe self-cleaning
cycle.
To remove the ovenbottom:
1. Removethe ovenshelves.
The ovendoor is removableto
makethe interiormore accessible
duringreplacementof thelamp
bulb.
Ovenshelvesmay be cleanedwitha
mildabrasivecleanserfollowing
manufacturer’sdirections.After
cleaning,rinse theshelveswith
cleanwateranddry witha clean
cloth. Toremoveheavy,burned-on
soil, soapymetalpadsmaybe used
followingmanufacturer’sdirections.
Aftersc~ubbing,washwithsoapy
water,rinse anddry.
oven Li@t Bulb
Open the ovendoor fullyand
removethe two Phillipsscrewsthat
hold the door to the hinges.Then
close thedoor to the automaticstop
position(at about3 inchesopen),
and lifi the door straightup and off
the hinges.(Dueto the largeamount
The lightbulb is locatedin the
upper leftcorner of the oven.
Beforereplacing the bulb,
disconnectelectric powerto the
range at the main fuse or circuit
breaker panel or unplugthe range
from the electric outlet. Let the
bulb cool completelybefore
removingit. Do not touch a hot
bulb with a damp cloth as the bulb
will break.
of insulationand the construction
ofthe door, it is heavy.)
2. Removethe twoknurled hold-
down screwsat the rear of the oven.
If they are too tightto removeby
hand, use a coin or screwdriver.
I
Note: Care shouldbe taken not to
place hands between the spring
hinge and the ovendoor frame as
the hinge could snap back and
pinch fingers.
To replace the door, make sure the
hinges are in the “out” position.
Positionthe slotsin the bottom of
the door squarely over the hinges.
Then lowerthe door slowly and
To remove: Hold hand under
lamp buIb cover so it doesn’tfall
when released. With fingers of
same hand, firmly push down wire
3. To lift out the ovenbottom,
bail ul]tilit ciears-c~ver.Lift off
cover. DO NOT REMOVE ANY
SCREWS TO REMOVE THIS
COVER. Replace bulb with a
40-wa[thome appliance bulb.
place your fingers in the slots in the
bottom and lift the rear of the oven
bottom up and back until the oven
bottomis clear of the lip at the front.
4. Then lift the bottom up and out.
To replace the bottom, place it in
the oven with the back raised about
ToIreplace
cover: Place cover into
groove of lamp receptacle. Lift
wire bail up to center of cover until
it snaps into place. When ii]place,
tvire holds cover firmly. Be certain
wire bail is not below depression
in center of cover.
evenly overboth hinges at the
same
time. If hinges snap back against
the ovenframe, p~ll them back out.
When the door is in position, open
it fully and insert tl~etwo
Phillips
screws.
6 to 8 inches or until you can insert
the front of the ovenbottom under
the hold-down lip at the front.
Then push the back of the oven
bottom down fully into place on the
metal flanges and insert the hold-
down
screMJs.