Filter
Top Products
A
3 Pin
2 Pin
Fan Motor
Light
Light
Green
Black
Black
Red
Red
White
Black
Black
White
White
Bare Copper
Ground
C22
Night Light
Night Light
Switch 1 (AC In)
Main Switch 1 (AC In)
Switch 2 (AC In)
*Option Fan & Main Light Together
*Option
Connect wires as shown.
C23
F
1
2
F
•
C24
2
G
C25
H
C26
H
C27
I
C28
ON
OF
F
C29
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
Tighten the wiring cover plate screw.
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
Secure the motor by tightening the 2 screws.
Turn on the power source.
Connect wiring from the motor to the wiring cover plate.
14
15
Test the motor. If the motor does not run, check the plug
connection.
C30
E1
Go to step
on page 18
to attach grille.
EXISTING FAN
D11
E
D12
Existing Construction – accessible only from below
Remove an existing fan and check to make sure the open-
ing is large enough to accommodate the new motor hous-
ing (9”x 9.75”).
Move the housing into position above the ceiling.
41723-01 12/25/2004 41723-01 12/25/2004