Filter
Top Products
IGSS-FMSS-0301
4
LOCATION
The refrigerated merchandisers have been designed for
use only in air conditioned stores where temperature and
humidity are maintained at or below 75°F and 55% rela-
tive humidity. DO NOT allow air conditioning, electric fans,
ovens, open doors or windows (etc.) to create air cur-
rents around the merchandiser, as this will impair its cor-
rect operation.
Product temperature should always be maintained at a
constant and proper temperature. This means that from
the time the product is received, through storage, prepa-
ration and display, the temperature of the product must
be controlled to maximize life of the product.
UNCRATING THE STAND
Place the fixture as close to its permanent position as
possible. Remove the top of the crate. Detach the walls
from each other and remove from the skid. Unbolt the
case from the skid. The fixture can now be lifted off the
crate skid. Lift only at base of stand!
EXTERIOR LOADING
These models have not been structurally designed to sup-
port excessive external loading. Do not walk on their
tops; This could cause serious personal injury and dam-
age to the fixture.
SETTING AND JOINING
The case that the FMSS connects to (the parent case)
through the rear of the case must be leveled and set prior
to installing the FMSS. The sectional construction of these
models enable them to be joined in line - to give the effect
of one continuous display. A joint Trim Kit is supplied with
each case line to cosmetically “mask” the sectional joints.
See the “Finishing Touches” section for more information
on joint trim.
LEVELING
IMPORTANT! It is imperative that cases be lev-
eled from front to back and side to side prior to
joining. A level case is necessary to insure proper
operation, water drainage, glass alignment, and
operation of the hinges supporting the glass. Lev-
eling the case correctly will solve most hinge op-
eration problems.
NOTE: A. To avoid removing concrete flooring, begin lineup
leveling from the highest point of the store floor.
B. When wedges are involved in a lineup, set them first.
All cases were leveled and joined prior to shipment to
insure the closest possible fit when cases are joined in the
field. When joining, use a carpenters level and shim legs
accordingly. Case must be raised correctly, under legs
where support is best, to prevent damage to case.
1. Check level of floor where cases are to be set.
Determine the highest point of the floor; cases will
be set off this point.
2. Level and set the first case, carefully guiding the
electrical, regfrigeration and drain lines through the
parent case. Case must be raised under legs where
support is best to prevent damage to case. Internal
bracing may be removed at this time.
3. Set second case as close as possible to the first case
carefully guiding its electrical, refrigeration and drain
lines through the parent case, and level case to the
first using the instructions in step one.
4. Apply masking tape 1/8" in from end of case on
inside and outside rear mullion on both cases to be
joined.
5. Apply
liberal bead of case joint sealant (butyl) to
dotted area shown in (Fig.2, #1) of first case. Apply
heavy amount to cover entire shaded area.
DO NOT USE PERMAGUM!
Fig. 2, #1
It is the contractor’s responsibility to install
case(s) according to local construction and
health codes.
6. Slide second case up to first case snugly. Then level
second case to the first case so glass front, bumper
and top are flush.
Do not use the top bracket on the rear mullion
to pull the cases together.
Installation (cont.)