Ice-O-Matic CD20030 CD20530 Beverage Dispenser User Manual


 
CD10022 CD20030
CD10522 CD20530
Final Check List/Initial Start Up
11
1. Check that electrical power has been supplied.
2. Check that a drain, separate from the ice
machine, insulated and made of rigid tubing,
has been connected to the dispenser.
3. Check that the ice machine has been properly
installed per the ice machine’s installation
directions.
4. Check that the machine/dispenser assembly
is level front to back and left ot right.
5. Check that optional kits, if any, have been
correctly installed.
6. Check that the front panel key, coin box key,
and key card if used, are available.
To Start:
1. Connect electrical power.
2. Go through ice machine start up procedures.
Let ice machine make two harvests.
3. Push vend switch button in and hold.
4. The dispensing whell will rotate and the vend
door solenoid will open the ice door.
5. Ice will be dispensed from the ice chute until
dispense switch is released.
6. Remove sink, and check drain area for leaks. If
none, replace sink.
7. Fill out the warrenty registration form, and
place it in the mail.
8. Give the operator the key(s) and instructions
on the operation and maintenance of the product.
Check that the operator knows who to call for
service, and has the product/service manuals for
the machines.
Electrical Sequence:
Pushing the dispenser switch closes the
contacts to the gearmotor and to the
ice door solenoid. The ice door solenoid
will open and the dispensing wheel will
start to turn bringing ice to the ice chute,
and ice is released to fall into the ice
container supplied by the customer. The
machine will continue to dispense ice as
long as the dispensing switch is held.
When the dispensing switch is released,
the dispensing wheel will stop and the
ice door solenoid will close.
This unit is equipped with and automatic
agitation cycle shich will cause the dispensing
wheel to rotate for approximately 3 seconds
every 2 hours. During this agitation cycle the
ice door will remain closed.