Ice-O-Matic ICEU070A Ice Maker User Manual


 
Cleaning Water System
1. Remove the ice from the bin.
2. Remove the air filter and then the front panel.
3. Rotate control knob counter clockwise to the Off
position.
4. Turn off the water supply to the ice machine.
5. Remove top panel.
6. Remove plastic panel (evaporator cover) that
covers evaporator section.
7. Remove clamp and drain cap from the bottom of
the reservoir, allow all the water to drain out.
8. Return the drain cap and clamp to their original
positions.
9. Mix approximately 3 ounces (1/10 liter) of Scale
Remover with 1.5 quarts (1.5 liter) of warm
(95-115
o
F.) potable water, and pour this solution
over the evaporator section (bright metal tubing
and inverted cups in white plastic tray at the top of
the ice machine).
10. Return the evaporator cover removed in step 6
to its normal position.
11. Rotate the control knob to the Normal position.
12. Operate the machine with the cleaning toggle
switch in the Operation position for 5 minutes.
13. Switch the cleaning toggle switch to the
Cleaning position and operate the machine for 1
minute.
14. Repeat steps 12 and 13 three times. After the
third time rotate the control knob counter clockwise
to the Off position.
15. Remove evaporator cover. Pour hot water over
the entire surface of the evaporator section. Return
evaporator cover to its original position.
16. Pour hot water into the bin to melt any ice
produced during cleaning, and to clean out the
drain. Wipe the interior of the bin with mild soap
and hot water, rinse with cold water.
To sanitize, mix a locally approved sanitizer
solution and perform steps 17-31. A possible
sanitizer solution may be obtained by mixing 1
ounce of household bleach with 2 gallons of warm
(95-115
o
F) water.
17. Remove plastic panel (evaporator cover) that
covers evaporator section.
18. Remove clamp and drain cap from the bottom
of the reservoir, allow all the water to drain out.
19. Return the drain cap and clamp to their original
positions.
20. Pour sanitizer solution over the evaporator
section (bright metal tubing and inverted cups in
white plastic tray at the top of the ice machine).
21. Spray or wash the bottom of the evaporator
cover and the edges of the evaporator section with
the sanitizing solution.
22. Return the evaporator cover removed in step
17 to its normal position.
ICEU070A
Page 15
Remove Drain Cap
Pour Scale Remover Over The Evaporator
Section
Ice machine cleaner contains acids. Acids can
cause burns.
If concentrated cleaner comes in contact with skin,
flush with water. If swallowed, do NOT induce
vomiting. Give large amounts of water or milk. Call
Physician immediately. Keep out of the reach of