Filter
Top Products
Specifications
The ice machine must be installed indoors in a
controlled environment.
Minimum Maximum
Air Temp 50
0
F. 95
0
F.
Water Temp 40
0
F. 100
0
F.
Water Pressure 20 PSI 80 PSI
Voltage 103.5 126.5
Operating the ice machine outside of the above
limitations, or outdoors, is potentially damaging to
the machine, and it is misuse of the machine. This
may void the warranty.
Ice-O-Matic ice machines are designed and
manufactured with the highest regard for safety
and performance. They meet or exceed the
standards of agencies like NSF and UL.
Ice-O-Matic assumes no liability or responsibility of
any kind for products manufactured by Ice-O-Matic
that have been altered in any way, including the
use of any part and/or other components not
specifically approved by Ice-O-Matic.
Ice-O-Matic reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.
UNPACKING AND INSPECTION
1. Call your authorized Ice-O-Matic Distributor or
Dealer for proper installation.
2. Remove the front panel of the unit and inspect
for any concealed damage. Notify carrier of your
claim for the concealed damage.
3. Check that refrigerant lines do not rub against or
touch other lines or surfaces, and that the fan
blade moves freely.
4. Check that the compressor fits snugly onto all its
mounting pads.
5. Remove all internal support packing and
masking tape.
ICEU070A
Page 2
15 3/16"
25 5/8"
16 1/8"
3 1/16"
11 5/8"
1 13/16"
8 1/8"
6"
4 11/16"
34 3/16"
28 7/8"
5/8"
Min for utility connections
2 11/16"
33/4"
1 9/16" Cord Set
3 7/16" Drain
3/4" GAS / BSPP
20 15/16"
Door Opening: 12 1/8" wide by 8 1/4" tall
Legs adjust to
6" from base.
Model Electrical (volts/Hz/phase) Fuse Size Amps Condenser Type Refrigerant Charge
ICEU070A 115/60/1 15 6 Forced Air 9.5 oz R-134a