Filter
Top Products
Quest Juice Training Manual
Publication Number: TP00968 - 8 - © 2004, IMI Cornelius Inc.
Pump Speed Switch
The pump speed switch has two settings, low and high. For most dispensing situations high speed will be
the preferred speed. Most concentrates use this setting. Low speed is only used when the water pres-
sure is at the low end of the range (25 PSI or less) and the concentrate is a very thin viscosity such as
apple or cranberry. Low speed cuts the output voltage to 18VDC.
Using a water booster system to increase the flowing pressure to the recommended pressure is a
better solution.
5.To change the brix setting, simply readjust the water flow rate.
Located on each of the valve assemblies inside the refrigerated
compartment are the adjusting screws for the water flow rate (one
per valve).
If the brix reading is too high or low, rotate the appropriate water flow
control according to the diagram below. Repeat steps 1-5 until the brix
setting is achieved.
IMPORTANT: When making changes to the water flow control, do not rotate more than 1/4 turn
per adjustment. Additionally, prior to taking your next brix reading, “tap” the corresponding dis-
pense button several times prior to drawing a sample. This will clear remnant drink from the dis-
pense nozzle AND help move the flow control to its new setting.
PROGRAMMING THE PORTION CONTROL
If your dispenser has optional portion controls, they have been pre-programmed from the factory to pour
7, 12, and 16 ounce drinks. The “extra large” (pitcher icon) size has also been pre-programmed to pour
16 ounces. To change the pour sizes, please follow the instructions below:
1.Simultaneously, press and hold “small” and “extra large” push button switches on the Portion
Control Module until the “Refill” light starts blinking. Release the switches. The blinking Refill
light indicates the programming mode is active.
2.Place the cup under the dispense nozzle and push the selected size button (small, medium,
large, or extra large). Hold the button in until the cup fills to the desired portion, then release
the button. Repeat the above procedure for the remaining sizes.
3.After programming all the drink sizes, press and release the “cancel/pour” switch to return
the Portion Control to the operational mode. The blinking REFILL light will go out.
4.If at a future date it is decided to change the portion size of the drinks, the individual sizes
can be adjusted by the above procedure. It is not necessary to reprogram every size. Additionally the
portion control has full memory retention in case of a power failure.
Cancel/Pour Button
To pour a drink without using a pre-programmed portion control size, simply push and hold the
Cancel/Pour button. Release when the glass is full.
Lowers Brix by increasing water
Raises Brix by reducing water