Filter
Top Products
Continuous Flow Icemaker Service Manual
© 2006, IMI Cornelius Inc. - 11 - Publication Number: 630460324SER
GEARMOTOR
OVERLOAD TRIPPED
Check water level control
and evaporator water tube
for line build-up restrictions.
Clear ice from
evaporator and
auger before
resetting overload.
CLEAN
CAUTION
See Instructions.
Overload
hot try
again.
YES
NO
Reset overload.
Resets but
motor does
not run.
Will not
Reset.
Icemaker
runs.
IMPORTANT
Will not
reset.
Replace
overload.
Resets but
motor does
not run.
Check
gearmotor
circuits.
Short run. Trips
again in 2
minutes. Check
gearmotor circuits.
Icemaker runs when
reset but problem has
not been found.
Continue checking for
overload as follows to
guard against future
problems.
OVERLOAD GUIDE
ELECTRICAL:
High or low voltage. Weak power lines can cause overloads on icemakers restarts.
High running current (2.4amps or above). Check motor circuits and start relay.
Auger delay failed.
ICEMAKER
Mechanical parts worn. Scored evaporator or auger. Worn thrust bearing.
Icemaker not turning off. Failed ice level control.
Over compression. Low water inlet temperature. Restrictions in water line from reservoir.
REFRIGERANT
Contaminated charge or bad compressor.
Low charge or gas leak.
Low suction pressure. Improper expansion valve. Sensing bulb location or insulation
and/or defective expansion valve.