Filter
Top Products
6
GB
Pry the fixing tab V and remove the oven burner
Unscrew the oven burner nozzle using the socket
spanner for the nozzles Z, or a 7 mm socket
spanner, and replace it with a nozzle suited to the
new type of gas (see Table 1).
Take particular care handling the spark
plug wires and the thermocouple pipes.
Replace all the parts, following the steps
described above in the reverse order.
b)Minimum regulation of the gas oven burner with
thermostat:
light the burner as described in the paragraph
the oven knob of the instruction booklet.
turn the knob to Max for about 10 minutes and
then turn the knob to the Min setting;
remove the knob;
regulate the screw positioned outside the
thermostat pin until the flame is small but steady.
in the case of liquid gas, the regulation screw
must be screwed in to the bottom.
check that the burner does not turn off when you
turn the knob from Max to Min and and when
you open and close the oven door quickly.
Adapting the gas grill to different types of gas
Replacing the nozzle of the grill burner:
remove the screw and then slide out the grill
burner V (see Figure);
unscrew the grill burner nozzle using the special
socket spanner for the nozzles (see Figure) or
better still a 7mm socket spanner; replace the
nozzle with a nozzle for the new type of gas (see
table 1).
Important
On completion of the operation, replace the old
rating sticker with one indicating the new type of gas
used. This sticker is available from our Service
Centres.
Note
Should the pressure of the gas used be different (or
vary) from the recommended pressure, it is
necessary to fit a suitable pressure regulator onto
the inlet pipe in compliance with current National
Regulations relative to regulators for channelled
gas.
V
I