Filter
Top Products
PAGE 5 OF 867161ĆX
PROGRAMMING (continued)
STEP
4
SETTING
THE RATE
STEP
5
SETTING
LOCK
PRESS DISPLAY REMARKS
This section of the menu is used to set up the rate informaĆ
tion.
ENTER
This sets the normalizing (averaging) factor. Press the arĆ
row keys under the desired digits to change. Press ``enter"
to enter displayed value.
PROG
ENTER
This section of the menu is used to set up the lockout type
and code number.
Press the ``PROG" key to choose SECS (rate per second),
minS (rate per minute) or HourS (rate per hour). Press ``enĆ
ter" to enter displayed choice.
This sets the number of significant figures to be displayed.
Press thearrow key underthe digitto change.Press ``enter"
to enter displayed value.
This sets the delay time (2 Ć 24 sec.) that the unit will ``look"
for valid input data before the display falls to ``0". Press the
arrow key under the digits to change. Press ``enter" to enter
displayed value.
LC PG = Locks program but presets and reset are accesĆ
sible (see description).
LC ALL = Locks all keypad buttons except ``start", ``stop"
and ``view".
Press the``PROG" button totoggle between choices. Press
``enter" to enter displayed choice.
PROG
PROG
PROG
PROG
PROG
PROG
PROG
PROG
ENTER
After ``code" flashes, the display will show the existing lock
code. To change the code, press the key under each digit
to be changed. Press ``enter" to enter displayed value. See
the following to turn lock on or off.
flashes
followed by:
#####
##
##
#
or
or
ENTER
ENTER
ENTER