InSinkErator H770 Water Dispenser User Manual


 
Star Nut
Fiber
Washer
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
Unscrew and remove threaded extension
from valve body. Do not discard, as you
will need this later (See Figure 1).
Leave small washers in place.
Feed tubes down through the hole in
the sink/counter until the base is at
rest. Set faucet at desired angle.
From under sink, slide 2
1
4" fiber washer
over faucet base. Reinstall threaded
extension onto the base until snug.
Thread star nut onto extension until
snug (See Figure 2).
From under sink, slide 2
1
4" fiber washer
over threaded extension. Thread star
nut onto extension until snug.
Hot & Cool models only
Attach the quick connector to the ends
of the copper tubes running from the
dispenser.
Install a white 3/8" tube into other end
of quick connector.
If sink/counter thickness exceeds 3/4"
a hole diameter of 1
1
2" is required.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
2
A
C
View/Wave
View/Wave
Hot & Cool models only
6
For a standard
1
1
2
"
sink/counter hole
Feed tubes down through the hole in
the sink/counter until the base is at
rest. Set faucet at desired angle.
Large washer required for sink holes larger
than
1
1
2
"
or for porcelain sinks with radius
or beveled holes.
Before feeding tubes through sink
hole, remove extension. Place 2
1
4"
large steel washer over threads on
faucet base. Reinstall extension.
B
View/Wave
Faucet is factory-ready for installation
into a standard 1
1
2" sink/counter hole.
1
5
8" Small
Steel Washer
2
1
4" Large
Steel Washer
1
5
8" Rubber
Washer
Standard 1
1
2" hole Hole larger than 1
1
2"
Installing into hole smaller than 1
1
2"
Star Nut
Fiber
Washer
Figure 1 Figure 2
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
1
5
8" Small
Steel Washer
1
5
8" Small
Rubber Washer
1
5
8" Small
Steel Washer
1
5
8" Small
Rubber Washer
INSTALLING THE FAUCET - VIEW/ WAVE