Filter
Top Products
Wing Nut
Fiber
Washer
■■
Unpack dispenser components.
■■
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
■■ Remove the wing nut from
the valve body.
HC3 only
■■ Attach the quick connector to the
ends of the copper tubes running
from the dispenser.
■■ Install a white 3/8" tube into
quick connector.
■■
■■ Feed tubes down through the hole
in the sink or counter until the base
is at rest.
■■ Make sure faucet head is at the
desired angle.
■■ Slide 2
1
⁄4" fiber washer over faucet
base under sink. Tighten assembly
using black plastic wing nut.
An extension is available by special order
(EXT-10) for counters more than 3/4" thick.
Call 1-800-558-5700 to order.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
2
A
C
D
HC3/GN3
HC3/GN3
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
From faucet
7
1
1
⁄4" Hole
Hole larger than 1
1
⁄4"
■■ For a 1
1
⁄4" sink hole, place the
washers on the faucet base in this
order (see diagram):
1) 1
5
⁄8" small steel washer
2) 1
5
⁄8" small rubber washer.
■■ For a hole larger than 1
1
⁄4", place the
washers on the facuet base in this
order (see diagram):
1) 1
5
⁄8" small steel washer
2) 1
5
⁄8" rubber washer
3) 2
1
⁄4" large steel washer
B
HC3/GN3
BOTH 1
5
⁄8" small steel and rubber washers
MUST BE INSTALLED to ensure
proper operation and seal.
1
5
⁄8" Small
Steel Washer
1
5
⁄8" Small
Steel Washer
2
1
⁄4" Large
Steel Washer
1
5
⁄8" Small
Rubber Washer
1
5
⁄8" Rubber
Washer
3/8" white tube
INSTALLING THE FAUCET - HC3/ GN3