InSinkErator H770 Water Dispenser User Manual


 
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
Make sure to use rubber gasket
to ensure proper seal.
2
B
A
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
Ensure that the black rubber gasket
is properly seated into the base of
the dispenser head and will
surround the sink mount.
Feed tubes down the hole in the
sink or countertop until the base is
at rest on the sink or countertop
surface.
From under the sink, place the
semi-circular mounting plate onto the
threaded stud.
Place wing nut onto the threaded
stud. Make sure faucet head is at the
desired angle. Tighten the wing nut
until snug, while ensuring the semi-
circular mounting plate extends
beyond the sink hole.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
C
H990
H990
H990
8
INSTALLING THE FAUCET - H990