Filter
Top Products
a 7/16” combination wrench or 7/16” nutdriver will be required in
order to hold the bolt head inside the control box.
Remove the locknuts from the opposite bolts used to hold down the
control box (do not remove the bolts) and secure the bracket to
underside of the hood. The folded part of the bracket should be fac-
ing the rear of the machine. Immediately tighten down the locknuts.
5. Remove the splash shield, which is bolted to the underside of
the hood next to the wash manifold and turn it 180B.
6. Remove the pawl bar and set to the side.
7. Remove the lower wash arm assembly by turning the locking
screw to unlatch it. The entire assembly should then lift out.
8. Remove the lower wash arm support bracket. Place it to the side
with its locknuts.
www.jacksonmsc.com
AJ-44 Conveyor Direction Change Instructions
Revision A (03/30/2005)
3
Removing bracket (bottom view)
Removing bracket (control box view)
Removing and turning splash shield
Remove the pawl bar by grapsing firmly and
lifting up.
Locking screw
Removing the locknuts for the lower wash arm
support bracket.