Filter
Top Products
Conveyor Switch Chart:
The chart above lists the conveyor switches and their functions,
depending on the direction fo travel for the machine. As you can
see, when you change the direction of the conveyor, you must also
alter the way the conveyor switches operate.
There is no need to remove the switches, only to change the wiring
inside the heater box.
34. Note: Before beginning any part of this maintenance evolution
that deals with the wiring of the machine, ensure that it is per-
formed by qualified technicians only. Always refer to the machine
schematic, located inside the control box, for any questions.
Wash Switch #1 and the Rinse Switch need to have their wire posi-
tions changed on the terminal board pictured above. Locate the
gray/yellow wire for Wash Switch #1 (do not confuse it with the
gray/yellow wire for Wash Switch #2) and the orange/yellow wire
for the Rinse Switch. Exchange their positions on the terminal
board.
35. Verify that the plumbing has been reassembled correctly and
that the hole cover weldment has been replaced and none of the
gaskets are torn or pinched as this could lead to leaking when the
machine operates.
35. Re-install the heater box cover.
AFTER MAINTENANCE ACTIONS
1. Reconnect the incoming water and drain lines and then
restore power to the unit. Run the unit for at least 1/2 hour to
ensure there are no leaks. Test the unit with an empty rack to
ensure that it pulls the rack all of the way through the unit. If any
problems arise you can contact Jackson Technical Service.
2. Replace the front dress panel once the unit is ready for
service again.
SPECIAL NOTES
1. There is a possibility that you may be required to short
-
en or lengthen the conduit and wire lengths for the inlet solenoid
on the rinse plumbing once it is moved. This work should be per
-
formed by qualified technicians who will do the work according to
applicable local, state and national codes. Questions concerning
this should be directed to Jackson Technical Service.
www.jacksonmsc.com
AJ-44 Conveyor Direction Change Instructions
Revision A (03/30/2005)
7
Unit
Direction
Switch #1 Switch #2 Switch #3
Left to Right Wash Switch #1 Wash Switch #2 Rinse Switch
Right to Left Rinse Switch Wash Switch #2
Wash Switch
#1
Terminal board inside the heater box
Incoming plumbing assembly for a Left to Right machine
(note hole cover weldment in lower right corner)
Incoming plumbing assembly for a Right to Left machine
(note hole cover weldment in upper left corner)