Filter
Top Products
tor weldment. Once removed, set to the side along with its gasket.
22. Separate the rinse plumbing from the rest of the incoming
plumbing by loosening the union. Ensure that the gasket on the
bottom of the rinse injector stays with the assembly as you remove
it.
23. Remove the remaining half of the union from the incoming
plumbing.
24. Remove the incoming water pressure regulator from the incom-
ing plumbing and replace with the union half that was removed in
step 23. Place the water pressure regulator on the end that the
union half was removed from.
25. Place the removed rinse plumbing assembly (with the gasket)
in the hole left open from when you removed the hole cover weld-
ment in step 21. Tighten the two halves of the union together.
26. Place the hole cover weldment (with its gasket) over the hole
from where the rinse plumbing assembly was originally installed.
Tighten down with the locknuts.
27. Re-install the rinse manifold (with its gasket) by connecting it to
the rinse injector weldment at its new location. Remove the locknut
from the stud for the bracket down near the rack rails and then
secure the bracket to the machine using the same lock nut.
28. Re-install the lower wash arm support bracket to the pawl bar
support on the end of the tub opposite from where it was removed.
29. Re-install the upper and lower rinse arms. Reinstall the lower
rinse arm support bracket.
30. Re-install the lower wash arm assembly, turning it 180B
and
locking it in place with the locking screw.
31. Re-install the pawl bar. Ensure that the pawl bar is placed so
that when racks are placed in the unit, the pawl bar dogs fold down.
32. Re-install the upper wash arm assembly. If you performed all of
the actions outlined in step 2, when you install it, it will be directly
over the lower wash arm assembly.
33. Remove the heater box cover by unscrewing the four screws
holding it on.
www.jacksonmsc.com
AJ-44 Conveyor Direction Change Instructions
Revision A (03/30/2005)
6
Removing the hole cover weldment
Loosening the union on the incoming plumbing
Removing the heater box cover
Front of rack conveyor showing the conveyor
switches
1
2
3