Filter
Top Products
Use the chart below to determine the initial time values for INITIAL RINSE, CYCLE RINSE, INITIAL SOAP, and CYCLE SOAP based
on the desired concentration of the chemical being used. Check the concentration of the chemicals after running a few cycles and read
-
just as necessary.
CHEMICAL TIMER ADJUSTMENTS CONTINUED
4
JPX-160
Chemical Ratio Chemical Chemical Initial Cycle Initial Cycle
(parts water to Concentration Concentration Rinse Rinse Detergent Detergent
one part chemical) (percent in water) (ounces per (sec) (sec) (sec) (sec)
10 gallons water)
5000 0.02% 0.3 7 4 3 1
3000 0.03% 0.4 12 7 5 1
2500 0.04% 0.5 14 8 6 2
2000 0.05% 0.6 18 10 8 2
1500 0.07% 0.9 24 14 10 3
1000 0.10% 1.3 36 20 16 4
800 0.13% 1.6 45 26 20 5
600 0.17% 2.1 60 34 26 6
400 0.25% 3.2 90 51 39 9
300 0.33% 4.3 119 68 52 13
250 0.40% 5.1 143 82 63 15
200 0.50% 6.4 179 102 78 19
I
N
S
T
R
U
C
T
I
O
N
S
JPX-200
Chemical Ratio Chemical Chemical Initial Cycle Initial Cycle
(parts water to Concentration Concentration Rinse Rinse Detergent Detergent
one part chemical) (percent in water) (ounces per (sec) (sec) (sec) (sec)
10 gallons water)
5000 0.02% 0.3 11 5 8 1
3000 0.03% 0.4 18 9 14 2
2500 0.04% 0.5 22 10 16 2
2000 0.05% 0.6 27 13 21 2
1500 0.07% 0.9 36 17 27 3
1000 0.10% 1.3 54 26 41 5
800 0.13% 1.6 67 32 52 6
600 0.17% 2.1 90 43 69 8
400 0.25% 3.2 134 64 103 12
300 0.33% 4.3 179 85 137 16
250 0.40% 5.1 215 102 165 19
200 0.50% 6.4 269 128 206 24