Filter
Top Products
9. Remove the lower rinse arm support bracket, which is mounted
directly opposite of the lower wash arm support bracket.
10. Remove the lower and upper rinse arms by unscrewing them
and then gently pulling them out.
11. Behind the rinse manifold, remove the nut on the bracket.
12. Remove the nuts from the rinse manifold mounting bracket
located on the underside of the hood. These nuts are mounted
directly to the rinse injector weldment on the hood top.
13. The rinse manifold must be removed. This may prove difficult
while the rinse injector is still mounted. With great care, it is possi
-
ble to gently lift the rinse injector off of the hood to allow the rinse
manifold to be removed from the unit. Ensure that the gasket in the
underside of the hood stays with the rinse manifold as it must be
replaced when re-installing the manifold. If the gasket becomes
lost or torn, order a new one immediately.
14. Remove the entire rinse tray assembly, including the pan and
the strainer within in. The assembly should lift right out. (See next
page for photograph detailing this step)
15. Remove the front and rear rinse pan locator brackets.
Note:
the brackets are mounted to the bolts that secure the tub
weldment to the frame.
Once the locknuts are removed, pull the
locator brackets off and immiediately replace the locknuts back
onto the bolts. Failure to do so at a minimum may cause excessive
leaking of the tub once the unit is placed back in operation.
www.jacksonmsc.com
AJ-44 Conveyor Direction Change Instructions
Revision A (03/30/2005)
4
Removing the lower rinse arm support bracket
Unscrewing and removing the lower rinse arm
Removing the bracket nut
Removing the locknuts from the rinse mani-
fold mounting bracket
Lifting the rinse injector to make room