Jackson Rack Conveyor Dishmachine Dishwasher User Manual


 
16. On the drain plumbing, the rinse drain tube needs to be
removed from the plumbing, as well as the wash drain tube. Both
of these tubes are secured with hose clamps. Loosen the hose
clamps and pull the tubes off.
17. The tee that the rinse drain nipple is in must be turned 180B
so
that it is facing the opposite direction. This may require dismantling
the plumbing by removing the tee with the wash drain barb in it. Put
the plumbing back together, after ensuring that the rinse drain tee
has been rotated. Use thread tape to protect the threads while put
-
ting the plumbing back together. Ensure that the wash drain barb
is in the exatc same position it was prior to this step.
18. On the underside of the tub, remove the rinse drain weldment
and the rinse drain plug. Switch their locations so that the rinse
drain weldment is in the spot that the rinse drain plug was in.
19. Reconnect the rinse drain hose and the wash drain hose to the
drain plumbing.
20. On the opposite end from where they were removed, install the
front and rear rinse pan assembly locating brackets.
Note: the
brackets are mounted to the bolts that secure the tub weld
-
ment to the frame.
Install the brackets one at a time and ensure
that they are firmly tightened down once installed.
21. Remove the hole cover weldment from the top of the hood. The
cover is located on the end of the hood opposite of the rinse injec
-
www.jacksonmsc.com
AJ-44 Conveyor Direction Change Instructions
Revision A (03/30/2005)
5
Lifting out the rinse tray assembly
Removing a rinse tray guide bracket
Loosening the rinse drain hose from the rinse
drain nipple
Removing the rinse drain weldment
Removing the rinse drain plug