Filter
Top Products
5
Cooktop Cartridge
Cooktop cartridges (conventional coil, halogen or radiant
element) can be installed on either side of the downdraft air grille
on models CVEX4270 and CVEX4370. Cartridges can be
installed only in one position on model CVEX4100. See the
“Assistance or Service” section for information on ordering.
To Install Cooktop Cartridge:
1. Be sure control knobs are in the “Off” position and the
cartridge is cool.
2. If the grill grates, element, and/or basin pan are in place,
remove before installing a cooktop cartridge.
3. Clean porcelain basin of any grease accumulation. See the
“Cooktop Care” section.
4. Position the cartridge terminal plug toward the terminal
receptacle.
5. With the side of the cartridge raised, slide the cartridge
toward the receptacle until the cartridge terminal plug is
completely engaged.
6. Lower the opposite side of the cartridge into the cooktop until
it is flush with the surface.
To Remove Cooktop Cartridge:
1. Be sure control knobs are in the “Off” position and the
cartridge is cool.
2. Remove the exhaust fan vent grille.
On model CVEX4370: To remove the right bay cartridge, first
remove the center bay cartridge.
3. Lift the cartridge side next to the ventilation chamber until the
top cartridge is about 3" (7.6 cm) above the cooktop.
NOTE: To avoid damaging the terminal plug, do not lift the
cartridge too high while it is still engaged in the receptacle.
4. To disengage terminal, hold cartridge by the ventilation
chamber side and slide away from the terminal receptacle.
Lift out when fully unplugged.
5. To avoid damage, do not stack cartridges where they may fall
or be damaged or store other materials on top of the glass
ceramic cartridges.
Install Grill
The grill accessory consists of two black grill grates, a grill
element and a basin pan. The grill can be installed on either side
of the downdraft air grille on models CVEX4270 and CVEX4370.
The grill can be installed only in one position on model
CVEX4100. See the “Assistance or Service” section for
information on ordering.
To Install Grill:
1. Be sure control knobs are in the “Off” position.
2. Place the basin liner pan into the empty basin.
3. Position the grill element with the terminal plug toward the
terminal receptacle. This receptacle is located at the front of
the left side of the cooktop and at the back of the right side of
the cooktop.
4. Slide the grill element toward the receptacle until the terminal
plug is completely engaged and all four supports rest on the
sides of the basin.
5. Place the grill grates on top of the cooktop.
To Remove Grill:
1. Be sure control knobs are in the “Off” position and the grill
components are cool.
2. Remove the grill grates.
3. To remove grill element, pull away from receptacle until it is
unplugged.
NOTE: To avoid damaging the terminal plug, do not lift the
grill element too high while it is still engaged in the receptacle.
A.Cartridge terminal plug
B.Terminal receptacle
A
B
A.Grill element terminal plug
B.Terminal receptacle
A
B